|
The DH-3N71 is the new generation in Shimano's power generating front hubs.
This new model is Ultegra/XT quality level, with double contact bearing seals and highly polished bearing surfaces. This
results in very low drag and good weather resistance.
Requires No Batteries
No worries about battery charge level.
Low drag, weather protected
Drag with the Nexus is only slightly higher than with the much more expensive Schmidt
hub. But far less than with a tire sidewall generator when the light is turned on.
Shimano's Dyno hubs can power most 6 Volt lights.
|
DH-3N71 |
|
100 mm |
|
108 (QR) |
|
36H or 32H |
|
14 and smaller |
|
yes (6V, 3W) |
|
80 mm |
|
740gm |
|
Basically the same as the DH-3N71 above, with the addition of a spline mount for use with Shimano disc brakes (disc sold separately.)
This hub comes with a protective rubber cap over the disc mount, so even if you don't immediately plan to invest in a front disc brake, you can use it in the meantime. |
 |
|---|
New! Problem Solvers Center-Lock Adaptor BRD120 $23.95/ea. 
The Problem Solvers Center-Lock adaptor allows 6-bolt rotors to be used on Center-Lock hubs.
Features and Information
Center-Lock
- Fits XTR, XT, LX, Deore and all Shimano Center-Lock patterned hubs.
- Does not fit XTR or XT wheelsets due to clearance issues with hub flange
- Does not fit Saint hubs due to the larger diameter of Center-Lock OS
- 6061-T6 anodized aluminum
- Troubleshooting: For easy installation, try using a cassette lockring. Install the lockring over the adaptor to push it all the way on, tighten the pinch bolt to proper torque, then remove lockring and install rotor. This helps ensure proper adaptor alignment. The lockwasher can be removed from the mounting bolt as it may cause the adaptor to twist out of alignment as bolt is tightened.
| |
Nexus Generator Connector Plug HU8216 $3.95

One of these plugs comes with each Shimano Nexus generator hub, but if you need extras, we have them. Easy to install, as illustrated below:


Generator Wheels
WE899 Front Wheel, DH-3N71 Hub / Sun CR-18 rim. $174.95

-
Stock front wheels.
- Built strong. DT Swiss double butted spokes, chromed brass nipples.
- Sun CR-18.
- Ready for your tube and tire.
- Combine with one of the lights below for a complete headlight system.
|  |
|---|

If you would like to make a link or bookmark to this page, the URL is:
http://harriscyclery.com/lighting/shimano.html
Copyright © 2005, 2008 Harris Cyclery | |